| Characteristics 特征 |
MAKROPOREsmasterbatches are designed for producing lightweight injection molded articles and /or for removing sink marks of injection molded products. MAKROPOREs secureextremely fine foam structure. Their active ingredient is an exothermic blowing agent based on azodikarbonamide. MAKROPOREs发泡母料是为生产轻质注塑成型制品和/或无痕塑料制品设计的母料。MAKROPOREs提供非常细密的发泡结构，其活性成分是基于偶氮二甲酰胺的放热发泡剂。 |
| Grades 级别 |
Makropore NAD 03 – contains bubble nucleating agent Makropore NAD 03——含有发泡成核剂 |
| Application 应用 |
Active components of THERMOBREAKpolymer consist of additives and stabilizer systems providing high resistance towards long-term heat exposure and ability to prevent the formation of burnt-in deposits in the ‘dead’ spaces of an extruder. The carrier matrix is polypropylene or low-density polyethylene.
THERMOBREAK母料的活性成分包括长效耐热的添加剂和稳定剂，能防止挤出机停机过程中形成煅烧沉积物。载体基质采用聚丙烯或低密度聚乙烯。 |
| Handling 操作 |
There is no special limitation when handling these products; only generally valid hygienic rules should be observed. 操作无特殊限制，只需遵循常规的卫生规范。 |
| Storage 储存 |
MAKROPOREs should be stored in a dry, cool and sheltered storage place. MAKROPOREs发泡母料应存储在干燥、阴凉和有遮盖物的场所内。 |
| Health Safety 健康安全 |
MAKROPORE is not designed for use in articles, which may come into contact with foodstuffs. MAKROPORE不允许用于与食品接触的制品中。 |
| General Information 基本信息 |
*decomposition of active ingredients starts at 165°C; the maximum is at 195°C *recommended letdown ratio is 1–2% wt. *masterbatches are simply mixed with basic material and dosed into the processing *equipment in an usual way *screw revolution should be maintained at min. 75 min–1 to obtain very fine bubble structure *温度达到165°C活性成分开始分解，温度195°C时达到最大值 *建议添加量为1–2% wt.。 *MAKROPORE发泡母料与原料简单混合后按照常规投料方式投料。 *螺杆转速应保持在最低75转/分钟，制品可获得非常精细的发泡结构。 |
